Includes high quality Japanese replacement parts in a complete kit.
Kit Includes:
-
OEM Toyota Complete Linkage Kit - 4x LHD Includes:
1 x TRET60021 Tie Rod Tube
1 x TRET60040 Relay Rod Tube
1 x TRET60010 Drag Link Tube
1 x TRE4669035OEM LH Tie Rod End
1 x TRE4669055OEM RH Tie Rod End
1 x TRE4669025OEM LH Relay Rod End
1 x TRE4569015OEM RH Relay Rod End
1 x TRE4769025OEM Drag Link End
1 x ST45442 Drag Link End
2 x TRET25CLAMPOEM Tie Rod Clamps
4 x TRET22CLAMPOEM Relay Rod & Drag Link Clamps - *Rear Drag Link is not available OEM, a high quality Japanese end (ST45442) is Included
If you are unsure on the proper fitment for your vehicle, please email info@cruiserteq.com with the full Model Code and Frame# / Vin#.
Fits 1968-84 4x Series LHD
FAQ: Do I need Zerk (grease) fittings on my new tie rod ends? What don't the new ones have them?
Japanese manufacture 555 no longer ships their tie-rod-end kits with Zerk fittings pre-installed. They cite the fact that far too many users in fact over-grease the joints and cause the boots to fail. Once the boots fail, the joint life is greatly reduced. If you're the type that likes to grease your joints on occasion and are comfortable with the fact you won't over grease them an blow the boot, simply swap the Zerk fittings from your old joints to the new set. Alternatively you can source the Zerk fittings's from a hardware or auto parts store. Otherwise, the joints come pre-greased and are ready for installation.
Tech Tip: Your steering ends will need to be painted either before or after you have installed them.
We prefer to install them first, wipe them down with some brake cleaner or paint prep and then use a piece of cardboard as a shield to give them a couple of quick coats of paint. You can pre-paint them but we recommend you mask off the threaded portion to prevent installation headaches. In either situation, use an anti-seize product on the threads into the actual tubes themselves.
