Front Axle AISIN Hub/Drive Flange Stud Hardware Set - Fits 1958 - 1/1998 4x/5x/6x/7x/8x Front Axle Applications - Pack of 6 (HUB6997KASET)

Would not buy again. The metal used for the stud and the nut is way too soft. I had to replace 3 studs on my hub, 2 of which stripped out immediately when I replaced them. After replacing the 2 BRAND NEW studs, one of them stripped again. I was tightening to spec of 23 ft lb. no reason these should strip that easily at that spec.

glad I had these on hand during my front rebuild, many of mine spun right out and cone washers were boogered. I tightened them to the 21 foot pounds and theyve been holding tight.

Purchased 2 sets of these to replace the old studs on the rear I hadn't gotten to yet and to keep one set on hand. Every single one either stripped the threads on the studs or stripped the threads in the nut. Opened the second pack and those stripped also. Reinstalled my old OEM studs and nuts - they torqued to 25ft lbs with no issue at all. I would spend the extra money and buy OEM.

Two problems - 1. Nuts are 13mm, not the 12mm found on the OE hardware. Minor inconvenience. 2. One stud stripped out at about 15ftlbs. I was using a beam type torque wrench in addition to a well calibrated arm. There's no reason this should have stripped out. I had to swap in one of the old studs I was replacing. Recommend you buy the OE hardware instead.

This kit was cheaper than the local dealer quoted for just the cone washers. I struggled removing a couple of the old original studs but everything reassembled very nicely.

Everything you need to mount hubs or drive flanges

Old ones fought coming off but the new ones were a breeze to install.. added a bit of red locktight for good measure

High quality parts, fast service.

While torquing the studs down, more than one was stripped, leaving the nut spinning freely on the stud.